Ht-instruments MACROTEST G3 Bedienungsanleitung PDF herunterladen (Seite 77)

MACROTESTG3 - COMBIG3

EN - 76

6. If the instrument detects that the phase and neutral

leads are inverted, it does not carry out the test and a

screen similar to the one reported to the side is

displayed. Rotate the shuko plug or check the

connection of measuring cables

7. If the instrument detects that the phase and PE leads

are inverted, it does not carry out the test and a screen

similar to the one reported to the side is displayed.

Check the connection of measuring cables

8. If the instrument detects a danger voltage on PE

conductor, it does not carry out the test and displays a

screen like the one to the side. This message can also

appair in case of an insufficient pressure of the

GO/STOP key

9. If the instrument detects a voltage VN-PE>50V (or

>25V depending on the selection), it does not carry out

the test and displays a screen like the one to the side

10 If during the measurement the instruments detects an

end of line impedance value lower than the initial line

impedance value it does not carry out the test and a

screen similar to the one reported to the side is

displayed. Check the status of the main line being

tested

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 107 108

Keine Kommentare

Ht-instruments MACROTEST G3 Bedienungsanleitung Seite 77